Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Technical characteristics
      + 7.2.2. Transmission diagnostics
      7.2.3. Draft of the selector of transmission
      7.2.4. System of fixing of the selector
      7.2.5. Cable of a drive of a zaslonka
      7.2.6. The blocking switch
      7.2.7. Transmission support
      7.2.8. Removal and transmission installation
   + 7.3. Transfer case
   + 7.4. Coupling, driveshafts, semi-axes and leading bridges
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

7.2.4. System of fixing of the selector

GENERAL INFORMATION

Arrangement of knots of system of fixing of the selector

1. Solenoid of blocking of a key
2. Solenoid of blocking of the selector
3. Control unit selector

4. Switch of blocking of the selector
5. Switch of a signal of braking

The system provides selector fixing in the provisions Park or Neutral at the pressed pedal of a brake. All works on system service except described are carried out in car-care center below.

Check

PERFORMANCE ORDER

1. For access to knots of system it is necessary to remove floor section.
	2. Disconnect the socket and submit tension from the battery on conclusions of the solenoid of blocking of the selector. If there is no characteristic click, the solenoid replace.

3. Disconnect the socket of the solenoid of blocking of a key and check resistance between conclusions 1и 5 (fig. at the left – for and/m 1991-95 гг), between conclusions 7 and 8 (fig. on the right – for and/m since 1995) which should be 12–17 Ohm.
	4. Disconnect the socket from the switch of blocking of the selector and check resistance between the specified conclusions.
5. In position of the Park selector between conclusions of R and Р1 there should be a chain.
6. In position of the Park selector and the pressed button between conclusions of R and Р1 and R and Р2 there should be a chain.
7. In other positions of the selector R, N, D, 2 and L R between conclusions and Р2 there should be a chain.
8. If results of checks differ, replace faulty details and repeat checks.