Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
- 10. Body
   10.1. Maintenance and repair
   10.2. Vinyl furnish
   10.3. Upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. Windscreen and motionless glasses
   10.8. Cowl
   10.9. Latch of a cowl and drive cable
   10.10. Forward lattice
   10.11. Forward wing
   10.12. Internal panel of a door
   10.13. Door lock, lock and handle switch
   10.14. Door glass
   10.15. Window regulator
   10.16. Lateral mirrors
   10.17. Door
   10.18. Door of a back compartment
   10.19. Back cover (the top door of a back compartment)
   10.20. Casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. Forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. Electric equipment
+ 12. Electroschemes









10.9. Latch of a cowl and drive cable

 Removal and installation

LATCH
PERFORMANCE ORDER
1. Outline a contour of a latch and unscrew fastening bolts to a front cross-piece. Remove a latch.
2. Disconnect from a latch a cable.
3. Installation is carried out upside-down.

DRIVE CABLE
PERFORMANCE ORDER
1. Disconnect a cable of a drive of a latch.
2. Attach to a cable a piece of a strong wire and following on the route of laying of a cable, disconnect the latches, fixing a cable cover to a body.
3. In salon unscrew fastening screws (are specified by shooters) handles of a cable of a drive of a latch of a cowl.
4. Get a cable, having extended it together with a sealant in salon until then yet the wire will not seem. Remove an old cable and attach to a wire a new cable together with a sealant.
5. Stretch a cable in a motor compartment, having undertaken a wire.
6. Installation is carried out upside-down. Establish a through sealant, having pressed on it fingers so that it came into an opening of a partition of a motor compartment.