Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
- 10. Body
   10.1. Maintenance and repair
   10.2. Vinyl furnish
   10.3. Upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. Windscreen and motionless glasses
   10.8. Cowl
   10.9. Latch of a cowl and drive cable
   10.10. Forward lattice
   10.11. Forward wing
   10.12. Internal panel of a door
   10.13. Door lock, lock and handle switch
   10.14. Door glass
   10.15. Window regulator
   10.16. Lateral mirrors
   10.17. Door
   10.18. Door of a back compartment
   10.19. Back cover (the top door of a back compartment)
   10.20. Casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. Forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. Electric equipment
+ 12. Electroschemes

10.23. Forward facing panel of salon


Fastening of facing of a guard of devices on FJ60 cars, 62

Bolts of fastening of the forward panel on FJ60 cars, 62

Bolts of fastening of the forward panel on FJ80 cars

1. Disconnect the battery from weight.
2. Remove a wheel (see subsection 9.9).
3. Remove average floor section.
4. Remove a box for trifles, facing of a guard of devices, facing of a radio tape recorder and a podkolennik from the driver.
5. Remove the receiver and a guard of devices.
6. Remove the control panel a heater.
7. Unscrew nuts and bolts of fastening of the assembly block of safety locks and the handle of a cable of a latch of a cowl.
8. On cars with injection of fuel remove the processor block which is mounted under a box for trifles.
9. Unscrew bolts and lower on a floor a steering column.
10. On FJ60 cars, 62 remove facing of a guard of devices.
11. Unscrew bolts of fastening of the panel.
12. Submit the panel on itself and disconnect all sockets which can prevent removal.
13. Raise the panel and remove.
14. Installation is carried out upside-down.