Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
   9.1. Technical characteristics
   9.2. Stabilizer of a forward suspension bracket and plug
   9.3. Lobbies and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (and/m FJ80)
   9.6. Cross-section bar (and/m FJ80)
   9.7. Suspension bracket levers (and/m FJ80)
   9.8. Rotary fist
   9.9. Steering wheel
   9.10. Steering drafts
   9.11. Reducer
   9.12. Pump of the hydraulic booster
   9.13. Air removal from the power steering
   9.14. Wheels and tires
   9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes


http://lemon62.ru/solikamsk/cat_1410.html






9.9. Steering wheel

Removal

PERFORMANCE ORDER
Prevention

The part of cars is equipped with a safety cushion which is in the container in the center of a steering wheel. To exclude casual operation of system disconnect the battery from weight and wait not less than 90 seconds (time of the category of the reserve condenser).
1. Expose a wheel in the provision of driving on a straight line and disconnect the battery from weight.
2. Get caps on each side a wheel and unscrew screws of fastening of the container with a pillow. Screws to turn on until then while the flute on a screw head will not come into an edge of an obechayka.
3. Remove the container with a safety cushion and disconnect the socket. An overlay of the container all the time keep in the direction from itself. To put the container with a pillow it is necessary so that the slip was turned up.
4. On cars without a safety cushion unscrew screws of fastening of a sound signal.
5. Unscrew a nut and designate the provision of a wheel concerning a shaft. Shaft rotation after removal of a steering wheel is not allowed.
6. Press a stripper a steering wheel. It is forbidden to remove a wheel in blows on a nave.

Installation

PERFORMANCE ORDER
1. Establish a steering wheel on a shaft.
2. If on cars with a safety cushion forward wheels were casually turned, it is necessary to center a spiral wire of a pillow. Be for this purpose convinced that wheels are exposed in situation on a straight line and turn the coil case counter-clockwise against the stop and turn on clockwise on 3 turns, having combined labels of red color.
3. Installation of a wheel is carried out upside-down. Combine labels and tighten a nut with the set moment. Attach the socket to a safety cushion.