Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
9.1. Technical characteristics
9.2. Stabilizer of a forward suspension bracket and plug
9.3. Lobbies and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (and/m FJ80)
9.6. Cross-section bar (and/m FJ80)
9.7. Suspension bracket levers (and/m FJ80)
9.8. Rotary fist
9.9. Steering wheel
9.10. Steering drafts
9.11. Reducer
9.12. Pump of the hydraulic booster
9.13. Air removal from the power steering
9.14. Wheels and tires
9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
FORWARD SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
Prevention
For removal of springs the adaptation for their compression is required.
|
| 1. Lift a front of the car and remove forward wheels. |
| 2. Establish supports under a bridge beam. |
| 3. Disconnect from a beam of the bridge of draft of the stabilizer and shock-absorbers. |
| 4. Carefully lower the bridge so that springs were completely stretched. |
|
5. Compress springs the adaptation. |
| 6. Remove springs. |
|
Installation
| PERFORMANCE ORDER |
| 1. Check a condition of springs, at detection of cracks or in case of corrosion of a spring replace. |
|
|
2. Compress a spring and establish in a place, having tracked correctness of installation of a spring (And) in the bottom cup (In). |
| 3. Further installation is carried out upside-down. |
|
BACK SPRINGS
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and remove wheels. |
| 2. Establish supports under a bridge beam. |
| 3. Disconnect from a bridge beam arms of the stabilizer and shock-absorbers. |
| 4. Unscrew a bolt of a cross-section bar and take a bar aside. |
|
5. Carefully lower the bridge so that springs were completely stretched. Remove a spring, having undertaken the bottom termination. |
| 6. Check a condition of springs, at detection of cracks or in case of corrosion of a spring replace. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation of back springs is carried out upside-down. |
| 2. Tighten all fastenings with the set moment. |
|
|
3. Track correctness of installation of springs. The bottom termination of a spring should rest against the cup limiter. |
|
|
|