Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
9.1. Technical characteristics
9.2. Stabilizer of a forward suspension bracket and plug
9.3. Lobbies and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (and/m FJ80)
9.6. Cross-section bar (and/m FJ80)
9.7. Suspension bracket levers (and/m FJ80)
9.8. Rotary fist
9.9. Steering wheel
9.10. Steering drafts
9.11. Reducer
9.12. Pump of the hydraulic booster
9.13. Air removal from the power steering
9.14. Wheels and tires
9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Details of a rotary fist
1. laying
2. Plug
3. Pin
4. Nut
5. Lever
6. Bearing |
7. Cover of the case of an epiploon
8. Persistent ring of the case of an epiploon
9. Fist
10. Bolt
11. Bearing cover
12. Remote laying |
Removal
| PERFORMANCE ORDER |
| 1. Lift a car front. |
| 2. Disconnect from a fist steering drafts. |
| 3. Remove brake details. |
| 4. Remove a semi-axis. |
|
5. Unscrew bolts of the case of an epiploon. |
|
6. Unscrew nuts of the lever and remove conic washers (are specified by shooters). |
|
7. Remove the top cover of bearings and remote laying. |
| 8. Remove bearings and designate them ("right top", "right bottom" etc.). |
| 9. Remove the remains of old greasing from bearings, a fork and a fist, having washed out solvent. |
| 10. Check a condition of bearings, existence on rollers of cracks, a vykrashivaniye and wear tracks. Check a condition of rings of bearings in forks. Worn-out bearings replace, having removed rings with blows on a brass opravka. Rings and holders of rollers change in a set. |
|
Installation
| PERFORMANCE ORDER |
|
|
1. Put in holders of bearings refractory greasing, with force having pressed on the bearing so that greasing came into holder separators. |
| 2. Apply a thin film greasings on the directing. |
| 3. Establish a new epiploon. |
| 4. Establish in a fork the top bearing, insert the bottom bearing. |
| 5. Holding the bottom bearing, dress a fist on a fork of the bridge and establish laying and the top cover. Wrap bolts. |
| 6. Establish the lever, conic washers, wrap nuts. Tighten nuts and bolts of covers of the top and bottom bearings with the set moment. |
|
7. Check a preliminary tightness in bearings. If the moment differs from normal, pick up thickness of remote laying, having removed a part of laying or having established the new. |
Prevention
The increase in thickness of laying reduces a preliminary tightness in bearings, reduction of thickness leads to increase in a tightness.
|
| 8. Further assembly is carried out upside-down. |
|
|
|