Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
   9.1. Technical characteristics
   9.2. Stabilizer of a forward suspension bracket and plug
   9.3. Lobbies and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (and/m FJ80)
   9.6. Cross-section bar (and/m FJ80)
   9.7. Suspension bracket levers (and/m FJ80)
   9.8. Rotary fist
   9.9. Steering wheel
   9.10. Steering drafts
   9.11. Reducer
   9.12. Pump of the hydraulic booster
   9.13. Air removal from the power steering
   9.14. Wheels and tires
   9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




9.4. Springs and plugs

Check of a condition of plugs

PERFORMANCE ORDER
1. On all cars in springs are established on two plugs, the condition and which density of a press fitting periodically should be checked.
2. For this purpose lift the car to remove weight from plugs, and shake a spring eye.
3. At existence люфта it is necessary to replace plugs.

Removal of springs

PERFORMANCE ORDER

Prevention

Described procedure is identical to lobbies and back plugs. It is recommended to change plugs on each party separately.


1. Lift the car and remove a wheel.
2. Will hang out a jack a bridge beam.
3. Disconnect the bottom fastening of the shock-absorber and take the shock-absorber aside.
4. Unscrew nuts of step-ladders, remove a plate and step-ladders.
5. Unscrew an earring bolt.
6. Remove a bolt of fastening of a spring to an arm of a frame and remove a spring.

Replacement of plugs

PERFORMANCE ORDER
1. Remove the plug, having rested a screw-driver from within.
2. If necessary moisten a place of a prileganiye of an eye and the plug with getting liquid and sustain time necessary for impregnation.
3. Slightly grease an eye with konsistentny greasing and press the new plug.

Spring installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Tighten bolts and nuts with the set moment.
3. Bolts of eyes of a spring tighten under nominal loading of the car.