Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
9.1. Technical characteristics
9.2. Stabilizer of a forward suspension bracket and plug
9.3. Lobbies and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (and/m FJ80)
9.6. Cross-section bar (and/m FJ80)
9.7. Suspension bracket levers (and/m FJ80)
9.8. Rotary fist
9.9. Steering wheel
9.10. Steering drafts
9.11. Reducer
9.12. Pump of the hydraulic booster
9.13. Air removal from the power steering
9.14. Wheels and tires
9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Prevention
Remove and establish each lever separately. If necessary to remove two and more levers remove springs and prop up the bridge a jack.
LEVERS OF THE FORWARD SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift a car front. |
| 2. Establish under the prop bridge. |
|
|
3. Unscrew a bolt nut on a frame arm. |
|
4. Unscrew nuts (are specified by shooters) on a bridge arm. |
| 5. Remove the lever. If necessary hook it mount. |
| 6. Check a condition of plugs of the lever, existence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car-care center as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Tighten all fastenings with the set moment. |
| 3. Bolts of fastening of the lever tighten under nominal loading of the car. |
|
LEVERS OF THE BACK SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car. |
| 2. Establish under the prop bridge. |
|
|
| 3. Unscrew nuts of bolts (fastenings of the top lever on a frame arm (fig. on the right) and the bridge (a photo at the left are specified by shooters)). Remove the top lever. |
|
|
| 4. Unscrew nuts of bolts of fastening of the bottom lever on a frame arm (fig. at the left) and the bridge (are specified by shooters a photo on the right). Remove the bottom lever. |
| 5. Check a condition of plugs of the lever, existence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car-care center as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Tighten all fastenings with the set moment. |
| 3. Bolts of fastening of the lever tighten under nominal loading of the car. |
|
|
|