Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
   9.1. Technical characteristics
   9.2. Stabilizer of a forward suspension bracket and plug
   9.3. Lobbies and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (and/m FJ80)
   9.6. Cross-section bar (and/m FJ80)
   9.7. Suspension bracket levers (and/m FJ80)
   9.8. Rotary fist
   9.9. Steering wheel
   9.10. Steering drafts
   9.11. Reducer
   9.12. Pump of the hydraulic booster
   9.13. Air removal from the power steering
   9.14. Wheels and tires
   9.15. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









9.3. Lobbies and back shock-absorbers
GENERAL INFORMATION

Shock-absorber of a lobby and back suspension bracket

 1, 11. Nut

2. Plate

3. Forward shock-absorber

4, 6, 8. Plate

5, 7. Plug

9. Nut

10, 12, 14. Buffer

13. Arm

15. Bolt

16. Back shock-absorber

17, 19. Plug

18. Washer

20. Bolt

21, 22. Plate

Removal

PERFORMANCE ORDER
1. Lift the car and remove a wheel. Substitute a support under a beam about the removed shock-absorber.
2. Disconnect the top fastenings of shock-absorbers. If necessary moisten a nut and a hairpin with getting liquid and hold a hairpin an alligator wrench (лыски on a hairpin small and can be easily broken).
3. Disassemble the bottom fastening and remove the shock-absorber.

Installation

PERFORMANCE ORDER
1. At installation be guided by the instruction attached to the new shock-absorber.
2. If pneumoshock-absorbers are established, a band cut off only after fixing of the top part of the shock-absorber.
3. Shake the shock-absorber up-down that plugs sat down in a place. Tighten the top nut and get the bottom earring on a fastening bolt, at the same time releasing a band (at installation of the new shock-absorber).
4. Tighten fastenings with the set moment.
5. Establish a wheel and lower the car.