Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
- 5. Fuel and exhaust systems
   - 5.1. Carburetor engines
      5.1.1. Fuel pump and pressure of fuel
      5.1.2. Gasoline pipe line
      - 5.1.3. Fuel tank
         5.1.3.1. Cleaning and repair of a fuel tank
      5.1.4. Fuel pump
      5.1.5. Fuel level sensor
      5.1.6. Air filter
      5.1.7. Cable of a drive of a butterfly valve
      + 5.1.8. Carburetor
      5.1.9. Service of an exhaust system
   + 5.2. Engines with fuel injection
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









5.1.3. Fuel tank
GENERAL INFORMATION

Fuel tank of cars of the series FJ60, FJ62
1. Separator паров
2. Connector of tubes
3. Stopper
4. Jellied mouth
5. Buffers
6. Fuel level sensor
 7. Laying
8. Tank
9. Coupling tapes
10. Drain stopper
11. Fuel pump

Fuel tank of cars of the FJ80 series
1. Ventilating tube
2. Hose
3. Hose of an inlet branch pipe
4. Mouth pipe
5. Stopper
6. Inlet pipe of a mouth
7. Tank
 8. Tank guard
9. Coupling tapes
10. Drain stopper
11. Laying
12. Slip
13. Buffers
14. Pump and fuel level sensor

Removal and installation
Prevention

At works observe fire safety regulations.

PERFORMANCE ORDER
Prevention

To remove a fuel tank follows after its full devastation. On some cars in a tank the drain stopper is provided. In the absence of a drain stopper devastate a tank a trip with the subsequent operation of the engine idling, or merge gasoline through a hose with the rubber manual pump (is available on sale).
1. Unscrew a stopper of a jellied mouth of a tank to remove residual pressure.
2. Disconnect the battery from weight.
3. Merge gasoline.
4. Lift the car and establish on supports.
5. Disconnect from a tank and muffle hoses and tubes.
6. Weaken a collar and disconnect from a tank a mouth.
7. Unscrew nuts and remove a tank guard.
8. Substitute under a tank a prop.
9. Disconnect coupling tapes and take aside.
10. Lower a tank a little and disconnect sockets and a wire on weight.
11. Remove a tank.
12. On a part of cars the additional tank which acts in film precisely in the same order is provided.
13. Installation is carried out upside-down.