Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. Transfer case
   - 7.4. Coupling, driveshafts, semi-axes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      + 7.4.3. Kardanny (е) shaft (ы), reducer and axes
      7.4.4. Forward semi-axis and epiploon
      - 7.4.5. Back (forward) bridge
         7.4.5.1. Reducer epiploon
         7.4.5.2. Semi-axis, bearing and epiploon (semi-unloading semi-axes)
         7.4.5.3. A semi-axis and an epiploon (completely unloaded semi-axes)
         7.4.5.4. A nave of a back wheel (completely unloaded semi-axes)
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









7.4.5.2. Semi-axis, bearing and epiploon (semi-unloading semi-axes)
GENERAL INFORMATION

Details of the back bridge with the semi-unloaded semi-axis
1. Clip of a cable of the hand brake
2. Cable
3. Reducer cover
4. Laying
5. Bearing
6. Epiploon
7. Drum
8. Laying
9. Maslootrazhatel
10. Semi-axis
11. Lock plate
12. Roller of satellites
13. Dividing plug
14. Pin

Semi-axes act in film for replacement of the bearing, an epiploon or removal of a reducer of the bridge.

Removal and installation

PERFORMANCE ORDER
1. Lift a back part of the car.
2. Remove wheels, disconnect a cable of the hand brake and remove drums.
3. Merge oil from a reducer.
4. Remove a back cover of a reducer.
5. Rotating reducer gear wheels, establish the roller in available situation.
6. Unscrew a bolt, get the roller and the dividing plug.
7. Ask the assistant to press a semi-axis and get from a semi-axis flute a lock plate.
8. Get a semi-axis, holding a canopy.
9. Check a bearing and epiploon condition.
10. If it is necessary to replace them, remove the bearing together with an epiploon a shock stripper with a two-maxillary nozzle.
11. Before semi-axis installation slightly grease epiploon edges with konsistentny greasing.
12. Assembly is carried out upside-down.
13. Tighten all fastenings with the set moment.
14. Fill in oil in a reducer.