Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. Transfer case
   - 7.4. Coupling, driveshafts, semi-axes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      - 7.4.3. Kardanny (е) shaft (ы), reducer and axes
         7.4.3.1. Check of driveshafts and hinges
         7.4.3.2. Removal and driveshaft installation
         7.4.3.3. Kardannye hinges
         7.4.3.4. A blocking nave
      7.4.4. Forward semi-axis and epiploon
      + 7.4.5. Back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

7.4.3.3. Kardannye hinges

GENERAL INFORMATION

Details of the kardanny hinge

1. Lock ring

2. Bearing

3. Crosspiece

4. A fork with a flange

Replacement

PERFORMANCE ORDER

1. Remove the driveshaft.
2. Clamp a shaft in a vice, designate the provision of forks of the hinge and get lock rings of glasses of bearings.
3. Vypressuyte bearing glass.
	4. For this purpose establish a crosspiece in a vice via the plug on the one hand and through an opravka with another.
	5. Compress a vice until then while the glass of the bearing will not appear at the edge of a fork. An alligator wrench or flat-nose pliers get a bearing glass.
6. Rearrange an opravka and the plug and выпрессуйте an opposite glass.
7. Having removed glasses, carefully clear a fork.
8. Put greasing in new glasses that at assembly needles were not scattered.
9. Establish a crosspiece and insert a glass into a fork.
10. Soriyentiruyte a crosspiece so that the direction of a butterdish coincided with the butterdish direction on the opposite end of a shaft (if butterdishes are provided).
11. Insert a crosspiece into the bearing, insert the opposite bearing.
12. Carefully, without having damaged epiploons, press bearings, having combined them with crosspiece necks.
13. Establish rings.
14. If necessary пристукните in strong blow on a fork that rings became in a place.
15. If rings do not come into flutes, disassemble the hinge and check freedom of rotation of bearings on crosspiece necks.
16. Establish the driveshaft.
17. Grease crosspieces (if there are butterdishes).