Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. Battery
      3.4.3. Power cables
      + 3.4.4. Ignition system
      3.4.5. Ignition coil
      3.4.6. Ignition distributor
      3.4.7. Block of electronic ignition
      3.4.8. Induction sensor
      + 3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay of a starter (and/m 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.4.10. Generator

GENERAL INFORMATION

Details of installation of the generator

1. Tank of the hydraulic booster
2. Adjusting arm
3. Wire
4. Socket

5. Generator
6. Belt
7. Lock bolt
8. Axis

Removal and installation

PERFORMANCE ORDER

1. To lower the engine and to connect to a coupling case.
	2. Disconnect from the generator sockets (are shown by shooters).
3. Weaken generator bolts (see fig. Details of installation of the generator).
4. Turn on and get adjusting and coupling bolts from an adjusting arm of the generator.
5. Remove the generator and an arm.
6. At acquisition of the new unit grasp with itself the old generator. Be convinced that the new generator in accuracy corresponds to the replaced. Pay attention to conclusions – their number, the sizes and a relative positioning should be same, as on the replaced unit. At last, check marking. Marking should be or is stamped on the case, or printed on a label and pasted on the case. Be convinced that numbers on new and replaced units coincide.
7. On many new generators there are no pulleys therefore it is necessary to rearrange a pulley from the replaced unit. At acquisition of the new generator consult concerning pulley installation.
8. Installation is carried out upside-down. Adjust a tension of a belt and check tension of a charge.