Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. Battery
      3.4.3. Power cables
      + 3.4.4. Ignition system
      3.4.5. Ignition coil
      3.4.6. Ignition distributor
      3.4.7. Block of electronic ignition
      3.4.8. Induction sensor
      + 3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay of a starter (and/m 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.4.3. Power cables

Check and replacement

PERFORMANCE ORDER

1. Periodically check cables on all length, damage, cracking or a burn-out of isolation of cables, and also corrosion are not allowed. Unreliable connection of the battery can cause refusals at engine start-up, and also deteriorations of operational qualities of the engine.

2. Check a condition of connections of poles with plugs, existence on them of corrosion, cracks and weakening of fastening of wires. Existence of a white being shelled raid under isolation in a place of the plug testifies to corrosion of conductors of a cable and need of its replacement.

3. Check existence of corrosion and deformations on plugs and a condition of bolts of fastening.

4. Disconnect from the battery old cables, track laying of cables on their length and find places of their fastening to a starter and to weight, disconnect cables from the traction relay of a starter and weight. Remember a route on which the cable is laid to lay a new cable to the place of the replaced. Track, that after installation the cable was not tense.

5. If cables are replaced new, getting new cables, grasp with itself old. It is the extremely important, that new cables in accuracy corresponded to the old.

6. Clear carvings of fastening of cables of the battery on the traction relay of a starter and on a body, remove corrosion traces.