Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. Battery
      3.4.3. Power cables
      - 3.4.4. Ignition system
         3.4.4.1. Check of system of ignition
      3.4.5. Ignition coil
      3.4.6. Ignition distributor
      3.4.7. Block of electronic ignition
      3.4.8. Induction sensor
      + 3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay of a starter (and/m 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.4.4.1. Check of system of ignition
GENERAL INFORMATION
Prevention

The system of ignition develops very high voltage therefore, at works it is necessary to observe electrosecurity rules.

PERFORMANCE ORDER
1. If the engine is not started, and the starter turns the crankshaft, disconnect high-voltage wires from candles and connect to them the calibrated rated sportsman, or disconnect a wire from one of candles, take away isolating tip and fix a wire at distance about 6 mm from the bared site of weight.
2. Turn the crankshaft a starter and watch a rated sportsman or a candle wire. There should be an intensive spark of blue color.
3. If the spark is available, on candles necessary tension moves (check other wires to be convinced of serviceability of a cover of the distributor and a begunka). Turn out candles and check.
4. If the spark is absent, or an iskroobrazovaniye unstable, uncover the distributor and check a condition of a cover and a begunka. At detection of moisture wipe dry a cover and a begunok, establish a cover on a place and repeat check.
5. If sparks on former are not present, disconnect from a distributor cover a high-voltage wire of the coil of ignition and connect a wire to a test rated sportsman or fix a coil wire at distance about 6 mm from weight.
6. If the spark appeared, malfunction of a cover of the distributor, a begunka or wires can be the reason.
7. In the absence of a spark check all conducting of primary chain of the coil of ignition, be convinced of purity and reliability of connections. Whether check tension on the coil from the ignition lock arrives. Check the ignition coil (see subsection 3.4.5) and the induction sensor of the distributor (see subsection 3.4.8). Execute necessary repair and repeat test.
8. If the spark on the former is absent, replace a wire connecting the coil of ignition and a distributor cover (check resistance of a wire and compare with standard). If replacement of a wire by the obviously serviceable does not give result, the electronic block of ignition is faulty.
9 whether. Check tension from the battery on the electronic block moves at ignition inclusion. If tension is absent, replace the electronic block.