Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Krylchatka of the fan and hydrocoupling
   4.5. Radiator and broad tank
   4.6. Maslookhladitel
   4.7. Pump of system of cooling
   4.8. Sensor of temperature of liquid
   4.9. Electric motor and chain of the fan of a heater
   4.10. Heater radiator
   + 4.11. Control panel heater and conditioner
   4.12. Central air and heating
   4.13. Conditioner moisture separator
   4.14. Conditioner compressor
   4.15. Condenser
   4.16. Evaporator and broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









4.10. Heater radiator
GENERAL INFORMATION

Below the order of removal of a radiator of a heater is in detail described. It is much simpler to remove a radiator after evaporator removal, however for this purpose it is necessary to depressurize previously the highway of central air and to remove a coolant.

To remove a heater radiator the manufacturer it is recommended to dismantle all dashboard and a steering column. For this purpose it is required to disunite a large number of sockets therefore there is a potential danger of breakage of fragile plastic latches, clamps etc. on various details. Application of this method independently in garage conditions is inexpedient because of its complexity.

On early models of a series 60 the radiator of a heater can be removed without dashboard dismantle.

Removal

PERFORMANCE ORDER
Prevention

Before the beginning of works disconnect a safety cushion.
1. Disconnect the battery from weight.
2. Merge cooling liquid.
3. Working from a motor compartment, disconnect heater hoses on a partition of a motor compartment.
4. Push a rubber sealant on a partition of a motor compartment in salon, having disconnected закраины sealants from opening edges in a partition.
5. Cнимите the central section, a perchatochny box, an overlay of a perchatochny box, an ashtray, the receiver with the obverse panel and the panel of forward facing of salon (see fig. Details of the dashboard and forward facing of salon of the FJ60 car, fig. Details of the dashboard and forward facing of salon of the FJ80 car).
6. Remove the control panel the heater / conditioner (see subsection 4.11).
7. Remove the electronic control unit, without disconnecting sockets and take aside to provide sufficient working space under the case of a radiator of a heater.
8. Remove heater brackets.
9. Unscrew bolts of fastening and remove the channel of the central air line.
10. Remove air line section assembled with a delitelny zaslonka which is directly over a radiator of a heater and it is a little displaced forward.
11. Weaken an inhaling of screws of fastening (are specified by shooters) heater branch pipes to the case.
12. Get a radiator from under the forward panel.
13. Spread on a floor rug a large number of rags for absorption of the spilled cooling liquid.
Prevention

At performance of this operation be careful not to damage plastic details of a heater. The radiator assembled with tubes can be removed, having carefully pulled from a wall of a motor compartment to release plastic ears from gearing with nearby details.
14. Installation is carried out upside-down.
15. Fill in liquid in cooling system, start the engine, be convinced of lack of leaks and check heater work.