Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Krylchatka of the fan and hydrocoupling
   4.5. Radiator and broad tank
   4.6. Maslookhladitel
   4.7. Pump of system of cooling
   4.8. Sensor of temperature of liquid
   4.9. Electric motor and chain of the fan of a heater
   4.10. Heater radiator
   + 4.11. Control panel heater and conditioner
   4.12. Central air and heating
   4.13. Conditioner moisture separator
   4.14. Conditioner compressor
   4.15. Condenser
   4.16. Evaporator and broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

4.15. Condenser


Bolts of fastening of the condenser

1. Drain hose

2. Bracket of the lock of a cowl

3. A tube with a liquid coolant

4. Collar

Removal and installation

1. Depressurize the conditioner and remove a coolant in car-care center.
2. Remove a radiator.
3. Remove a decorative lattice, a bracket of the lock of a cowl and the central rack.

4. Disconnect the coolant highway on the right side, having unscrewed a bolt (it is specified by an arrow), muffle the union of tubes of a coolant.
5. Unscrew bolts of fastening of the condenser, displace the condenser back and remove from the car.
6. Establish the condenser and arms, wrap bolts.
7. Be convinced of reliability of fastening of rubber pillows on the condenser.
8. Attach coolant tubes, replace ring laying.
9. If the new condenser is established, enter 50 cubic see fresh oil of recommended brand.
10. Other details are established upside-down.
11. Fill the conditioner with a coolant (it is carried out in the same workshop in which depressurization and coolant removal were carried out).