Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Krylchatka of the fan and hydrocoupling
   4.5. Radiator and broad tank
   4.6. Maslookhladitel
   4.7. Pump of system of cooling
   4.8. Sensor of temperature of liquid
   4.9. Electric motor and chain of the fan of a heater
   4.10. Heater radiator
   + 4.11. Control panel heater and conditioner
   4.12. Central air and heating
   4.13. Conditioner moisture separator
   4.14. Conditioner compressor
   4.15. Condenser
   4.16. Evaporator and broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









4.7. Pump of system of cooling
GENERAL INFORMATION

The pump of cooling liquid of the engine 3F-E
1. Perepuskna hose
2. Hose of a maslookhladitel
3. Laying
4. Pump
5. Pulley flange
6. Drive belt
 7. Hydrocoupling
8. Krylchatka
9. Pulley
10. Inlet hose
11. Pump plate
12. Heater hose

The pump of cooling liquid of the engine 1FZ-FE
1. Laying
2. Pump
3. Pulley
4. Drive belt
5. Inlet hose
 6. Casing
7. Krylchatka
8. Perepuskna hose
9. Hydrocoupling

Check

PERFORMANCE ORDER
1. On the working heated-up engine carefully press the top hose of a radiator and gradually release. At the serviceable pump in a hose the liquid pressure should be felt.
2. In the pump the control opening for a liquid drain is provided. At failure of an epiploon of the pump through a control opening cooling liquid follows. To find this opening, it is necessary to illuminate space behind a conducted flange of the pump, directly under shaft.
3. It is possible to define wear of bearings, shaking the pump up and down, and on characteristic howl in a forward part of the engine.
4. The close sound on a tonality can publish and a sliping belt of a drive therefore it is possible to draw an erroneous conclusion on malfunction of the pump.
5. To exclude a sound from a belt, put with dispersion special structure for automobile belts.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight and merge cooling liquid (see subsection 2.38).
2. Remove all belts of hinged units.
3. On cars till 1992 remove a roller of a natyazhitel of a belt of the conditioner and an arm, and also a bracket of fastening of the generator.
4. Remove a casing of the fan and the fan (see subsection 4.4).
5. Remove from the pump a pulley and disconnect hoses.
6. Unscrew bolts (are specified by shooters) and remove the pump.
7. Disassemble the pump and replace laying.
8. Carefully clear the demountable plane of a cover of the laying remains.
9. Installation is carried out upside-down.
10. Bolts tighten with the set moment.