Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Additional maintenance
   2.2. Technical characteristics
   2.3. An arrangement of units in a motor compartment
   2.4. Maintenance terms
   + 2.5. Check of level of liquids
   2.6. Check of a condition of tires and pressure in tires
   2.7. Liquid level in automatic transmission
   2.8. Liquid level in system of a hydraulic actuator of a steering
   2.9. Oil replacement in the engine and the oil filter
   2.10. Check of a condition and care of the battery
   2.11. Check of system of cooling
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check and replacement of brushes of a cleaner of a windscreen
   2.14. Shift of wheels
   2.15. Suspension bracket and steering check
   2.16. Check of an exhaust system
   2.17. Check of level of oil in a manual transmission
   2.18. Check of level of oil in a transfer case
   2.19. Check of level of oil in reducers of bridges
   2.20. Check of a condition of seat belts
   2.21. Thermostat of the air filter (carburetor engines)
   2.22. Check and greasing of the exhaust valve
   2.23. Catching system паров gasoline
   2.24. Check of system of a retsirkulyatsiya
   2.25. Air zaslonka of the carburetor
   2.26. Zolotnik of system of ventilation of a case
   2.27. Check and replacement of the air filter
   2.28. Replacement of spark plugs
   2.29. Check and adjustment of gaps of valves
   2.30. Idling turns (carburetor engines)
   2.31. Drive belts
   2.32. Check of fuel system
   + 2.33. Check of brakes
   2.34. Check and adjustment of pedals of coupling (brake)
   2.35. Replacement of the fuel filter
   2.36. High-voltage wires, begunok and distributor covers
   2.37. Check and installation of the moment of ignition
   2.38. Care of cooling system
   2.39. Naves and bearings of forward wheels
   2.40. Liquid replacement in automatic transmission and the filter
   2.41. Oil replacement in a manual transmission
   2.42. Oil replacement in a transfer case
   2.43. Oil replacement in a back (forward) reducer
   2.44. Gaps in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









2.38. Care of cooling system
GENERAL INFORMATION

Arrangement of a drain stopper of cooling liquid

1. Drain stopper of the block of cylinders (all cars)

2. A drain stopper of a radiator on cars of late release

3. A drain stopper of a radiator on cars of early release
Prevention

Works are carried out on the cold engine at observance of precautionary measures (antifreeze is poisonous).

Replacement of liquid and washing

PERFORMANCE ORDER
1. Substitute a vessel under a drain stopper of a radiator.
2. Two flat-nose pliers unscrew a drain stopper and a stopper of a mouth of a radiator (press and turn against a chasosy arrow). Merge liquid. Then unscrew a stopper and merge liquid from the block of cylinders (if liquid does not pour down, punch a screw-driver a rust in a drain opening).
3. Check and if necessary replace the damaged hoses of system of cooling.
4. Wash out a radiator a stream at its finest (deletes only a deposit), if necessary wash out special detergent (deletes rust stratifications). If to wash out a radiator it is not possible, or if there are appreciable damages and a leak, remove a radiator and hand over in repair.
5. Disconnect a tank hose, merge liquid, wash out a tank and dress a hose.
6. Tighten both drain stoppers.
7. Transfer a heater rychazhok to the provision of the maximum heatreturn.
8. Fill in liquid (in the ratio 50/50 waters and antifreeze) to the bottom mark of a tank.
9. Without closing a stopper a radiator, warm up the engine before thermostat opening (it is felt on heating of the top hose).
10. Stop the engine and after cooling fill in liquid to edge of a mouth, having pressed on a hose, remove air then wrap a stopper.
11. Start the engine and be convinced of lack of a leak.