Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Additional maintenance
   2.2. Technical characteristics
   2.3. An arrangement of units in a motor compartment
   2.4. Maintenance terms
   + 2.5. Check of level of liquids
   2.6. Check of a condition of tires and pressure in tires
   2.7. Liquid level in automatic transmission
   2.8. Liquid level in system of a hydraulic actuator of a steering
   2.9. Oil replacement in the engine and the oil filter
   2.10. Check of a condition and care of the battery
   2.11. Check of system of cooling
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check and replacement of brushes of a cleaner of a windscreen
   2.14. Shift of wheels
   2.15. Suspension bracket and steering check
   2.16. Check of an exhaust system
   2.17. Check of level of oil in a manual transmission
   2.18. Check of level of oil in a transfer case
   2.19. Check of level of oil in reducers of bridges
   2.20. Check of a condition of seat belts
   2.21. Thermostat of the air filter (carburetor engines)
   2.22. Check and greasing of the exhaust valve
   2.23. Catching system паров gasoline
   2.24. Check of system of a retsirkulyatsiya
   2.25. Air zaslonka of the carburetor
   2.26. Zolotnik of system of ventilation of a case
   2.27. Check and replacement of the air filter
   2.28. Replacement of spark plugs
   2.29. Check and adjustment of gaps of valves
   2.30. Idling turns (carburetor engines)
   2.31. Drive belts
   2.32. Check of fuel system
   + 2.33. Check of brakes
   2.34. Check and adjustment of pedals of coupling (brake)
   2.35. Replacement of the fuel filter
   2.36. High-voltage wires, begunok and distributor covers
   2.37. Check and installation of the moment of ignition
   2.38. Care of cooling system
   2.39. Naves and bearings of forward wheels
   2.40. Liquid replacement in automatic transmission and the filter
   2.41. Oil replacement in a manual transmission
   2.42. Oil replacement in a transfer case
   2.43. Oil replacement in a back (forward) reducer
   2.44. Gaps in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









2.11. Check of system of cooling
GENERAL INFORMATION

The reason of many characteristic engine failures is malfunction of system of cooling. On cars with automatic transmission the condition of system of cooling essentially influences durability and non-failure operation of work of transmission.

The system of cooling is checked on the cold engine. Check system to a trip, or not less than 3 hours later after an engine stop.

PERFORMANCE ORDER
1. Turn a radiator stopper to the left against the stop. If hissing (that testifies to residual pressure) is heard, a stopper do not get before complete dumping of pressure. Now press a stopper a palm, tighten to the left and get a stopper. Carefully wash out a stopper pure water, wipe a radiator mouth pure rags. Remove all traces of corrosion. Cooling liquid in a radiator should be transparent. If cooling liquid is painted in color of a rust, system it is necessary to wash out and replace liquid. If level of cooling liquid is lower than edge of a jellied mouth, add a water and antifreeze mix (see subsection 2.5.2).
2. Check a condition of the top and bottom hoses of a radiator and heater hoses. Examine hoses on all length, at detection of swelling of hoses, cracks and the general deterioration of a condition a hose replace. Cracks are easily found if a hose to press. Irrespective of a condition of hoses it is recommended to change them each two years.
3. Be convinced of durability of all connections. Leakage of cooling liquid can be found on a raid of white or brown color near a place of violation of tightness. If hoses are fixed by wire collars, it is necessary to replace the last with collars with screw fastening.
4. With the compressed air or a brush remove from intercostal spaces of a radiator and the conditioner condenser the remains of insects, plants and extraneous subjects, thus do not injure a radiator or condenser edge. Be careful, as edges have sharp edges.