Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Additional maintenance
   2.2. Technical characteristics
   2.3. An arrangement of units in a motor compartment
   2.4. Maintenance terms
   + 2.5. Check of level of liquids
   2.6. Check of a condition of tires and pressure in tires
   2.7. Liquid level in automatic transmission
   2.8. Liquid level in system of a hydraulic actuator of a steering
   2.9. Oil replacement in the engine and the oil filter
   2.10. Check of a condition and care of the battery
   2.11. Check of system of cooling
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check and replacement of brushes of a cleaner of a windscreen
   2.14. Shift of wheels
   2.15. Suspension bracket and steering check
   2.16. Check of an exhaust system
   2.17. Check of level of oil in a manual transmission
   2.18. Check of level of oil in a transfer case
   2.19. Check of level of oil in reducers of bridges
   2.20. Check of a condition of seat belts
   2.21. Thermostat of the air filter (carburetor engines)
   2.22. Check and greasing of the exhaust valve
   2.23. Catching system паров gasoline
   2.24. Check of system of a retsirkulyatsiya
   2.25. Air zaslonka of the carburetor
   2.26. Zolotnik of system of ventilation of a case
   2.27. Check and replacement of the air filter
   2.28. Replacement of spark plugs
   2.29. Check and adjustment of gaps of valves
   2.30. Idling turns (carburetor engines)
   2.31. Drive belts
   2.32. Check of fuel system
   + 2.33. Check of brakes
   2.34. Check and adjustment of pedals of coupling (brake)
   2.35. Replacement of the fuel filter
   2.36. High-voltage wires, begunok and distributor covers
   2.37. Check and installation of the moment of ignition
   2.38. Care of cooling system
   2.39. Naves and bearings of forward wheels
   2.40. Liquid replacement in automatic transmission and the filter
   2.41. Oil replacement in a manual transmission
   2.42. Oil replacement in a transfer case
   2.43. Oil replacement in a back (forward) reducer
   2.44. Gaps in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes


shopescort







2.6. Check of a condition of tires and pressure in tires

GENERAL INFORMATION

Characteristic type of drawing of a protector at abnormal wear of tires

1. Insufficient pressure in the tire
2. Non-uniform wear because of violation of corners of installation of forward wheels
3. The strengthened lateral wear of a protector
4. An elevated pressure in tires
5. Cross-section angular wear of a protector (violation of corners of installation of wheels)



 

Reasons and ways of elimination:

Check pressure and restore to the normal.
Balancing violation, disk deformation – отбалансировать a wheel and to replace a disk.
Wear or raised люфт in the pendular lever or in drafts – to repair.
To repair or replace suspension bracket details.

On a condition of tires it is possible to receive important information on a suspension bracket and steering condition still before serious damage will be found.
PERFORMANCE ORDER
1. Wear of tires can be checked by means of the indicator of depth of a protector. In tires the special bandage which becomes visible at residual depth of a protector of 1,6 mm is built in.
2. Watch drawing of a protector of tires (see fig. A characteristic type of drawing of a protector at abnormal wear of tires). Evident signs of non-uniform wear of the protector, specified in pictures, indicate need of adjustment of corners of installation or balancing of wheels. At detection of a deviation of wear of tires from the normal it is necessary to hand over the car in car-care center.
3. Regularly check tires, watch emergence of damages to a type of cuts or swellings, delete the stones which have got stuck in a protector or sharp subjects. If weak pressure decrease in tires is observed, check tightness of the gate for a rating.
4. If there is a suspicion that the tire is punctured, check a place of a possible puncture by means of soap solution. Lift the car from the lowered wheel and, turning a wheel, обмыльте its solution. In case of leak formation of bubbles will be observed.
5. Carefully check internal lateral surfaces of tires, watch emergence of traces of a podtekaniye of brake liquid on them.
6. Periodically check and support pressure in tires.
7. Pressure is checked on cold tires. The term "cold" means that in 3 hours prior to pressure measurement the car made one trip on distance of 1,5 km.
8. Unscrew a gate cap (it is located on the tire or under a wheel cap) and densely press a manometer to the gate. Consider indications of a manometer and compare with standard (it is specified on the plate of the manufacturer strengthened on a rack of an aperture from the driver). If necessary restore pressure to norm.
9. Keep in mind that pressure in a compact spare wheel is much higher than pressure in regular tires.