| 1. Lift the car and remove wheels. |
| Check of disk brakes |
|
|
2. Blocks can be checked through a window in a support (it is specified by an arrow). |
| 3. Measure thickness of frictional slips and if thickness less specified in subsection 8.1, replace blocks. |
| 4. If there are any doubts of rather normal state of slips, blocks should be removed. |
| 5. At the same time measure thickness of a disk and check a surface condition (irrespective of its thickness). If the thickness is less than norm, a disk replace. Insignificant defects of a surface are removed polishing, strongly worn-out disk replace. |
|
6. Check a hose condition (the place of check is specified by an arrow) and tubes of a hydraulic actuator of brakes. Check reliability of an inhaling of connections, absence of contact with moving parts. All found defects immediately eliminate. |
| Check of drum-type brakes |
| 7. Remove drums (see subsection 8.6). |
|
8. Check thickness (And) frictional slips. If their thickness (or distance to heads of rivets) is less than 1,6 mm, or there are traces of a zamaslivaniye or serious damages, blocks replace. |
| 9. Check a condition of springs and a gap regulator between blocks and drums. |
|
10. Check podtekany liquids from the wheel cylinder, having unbent a dustproof cover. At leak detection the cylinder replace. |
| 11. Check a condition of drums. Minor defects polish a skin, if necessary drums pierce. |
| 12. Establish all removed details and lower the car. Wheel nuts tighten with the set moment. |