Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Additional maintenance
   2.2. Technical characteristics
   2.3. An arrangement of units in a motor compartment
   2.4. Maintenance terms
   - 2.5. Check of level of liquids
      2.5.1. Oil level in the engine
      2.5.2. Cooling liquid
      2.5.3. Liquid of a washer of a windscreen
      2.5.4. Electrolit of the storage battery
      2.5.5. Liquid of a hydraulic actuator of brakes and coupling
   2.6. Check of a condition of tires and pressure in tires
   2.7. Liquid level in automatic transmission
   2.8. Liquid level in system of a hydraulic actuator of a steering
   2.9. Oil replacement in the engine and the oil filter
   2.10. Check of a condition and care of the battery
   2.11. Check of system of cooling
   2.12. Check and replacement of hoses in a motor compartment
   2.13. Check and replacement of brushes of a cleaner of a windscreen
   2.14. Shift of wheels
   2.15. Suspension bracket and steering check
   2.16. Check of an exhaust system
   2.17. Check of level of oil in a manual transmission
   2.18. Check of level of oil in a transfer case
   2.19. Check of level of oil in reducers of bridges
   2.20. Check of a condition of seat belts
   2.21. Thermostat of the air filter (carburetor engines)
   2.22. Check and greasing of the exhaust valve
   2.23. Catching system паров gasoline
   2.24. Check of system of a retsirkulyatsiya
   2.25. Air zaslonka of the carburetor
   2.26. Zolotnik of system of ventilation of a case
   2.27. Check and replacement of the air filter
   2.28. Replacement of spark plugs
   2.29. Check and adjustment of gaps of valves
   2.30. Idling turns (carburetor engines)
   2.31. Drive belts
   2.32. Check of fuel system
   + 2.33. Check of brakes
   2.34. Check and adjustment of pedals of coupling (brake)
   2.35. Replacement of the fuel filter
   2.36. High-voltage wires, begunok and distributor covers
   2.37. Check and installation of the moment of ignition
   2.38. Care of cooling system
   2.39. Naves and bearings of forward wheels
   2.40. Liquid replacement in automatic transmission and the filter
   2.41. Oil replacement in a manual transmission
   2.42. Oil replacement in a transfer case
   2.43. Oil replacement in a back (forward) reducer
   2.44. Gaps in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

2.5.2. Cooling liquid

GENERAL INFORMATION

Broad tank

The broad tank (it is specified by an arrow) the white color, established behind a radiator, is connected by a hose to the basis of a stopper of a jellied mouth of a radiator.

All cars considered in this Management, have the closed tight system of cooling of an elevated pressure.

In process of heating of cooling liquid in operating time of the engine there is a replacement of liquid of a jellied mouth in a broad tank. In process of engine cooling cooling liquid flows down back in cooling system.

Level of cooling liquid should be checked regularly. Level should be between marks in Full tank (Full) and Low (Nizhny). Depending on engine temperature level will change. On the cold engine, level of cooling liquid should be a little higher than Low mark. On the heated-up engine level should coincide with Full mark, or be near this mark.

PERFORMANCE ORDER

1. If the provision of level does not correspond specified, after liquid cooling in a tank remove a stopper and add cooling liquid to Full mark. It is necessary to add only liquid on a basis этиленгликоля and waters, it is forbidden to add anticorrosive additives independently. The recommended composition of liquid in system of cooling is specified in the car maintenance instruction.

2. If it is necessary to turn out a stopper of a jellied mouth of a radiator, wait complete cooling of system, then wrap up a stopper a thick layer of rags and turn it to the first emphasis. At emergence of steam wait while liquid will cool down completely, then turn out a stopper.

3. At check of level of liquid always watch its condition. It should be rather transparent. If liquid gained brown color, or color of a rust, it is necessary to replace it, previously having washed out cooling system. Anticorrosive properties are exhausted over time, though liquid and can keep satisfactory appearance.

4. Do not allow antifreeze hit on skin or on the painted surfaces of the car. In case of hit immediately wash out them a large amount of water.

5. If later a short period after a dolivaniye level of liquid goes down, violation of tightness of system is possible. Check a radiator, hoses, a stopper of a jellied mouth, an inhaling of drain jams, and the water pump. If obvious signs of a leak it is not revealed, check a radiator stopper, having handed over it in a car-care center workshop.