Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Air removal from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the hand brake of back disk brakes
   8.13. Adjustment of the hand brake
   8.14. Cable of the hand brake
   8.15. Switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

8.13. Adjustment of the hand brake

GENERAL INFORMATION

The hand brake should provide braking on a bias at 5 clicks of a course. Adjustment is necessary, if a course of a brake or less than 4 or more than 5 clicks.

PERFORMANCE ORDER

1. Remove the central section then access to a regulator is provided.
	2. Release a lock-nut (the top nut), holding an adjusting (bottom) nut.
3. Tighten an adjusting nut before receiving the necessary course of the lever of a brake.
4. Tighten a lock-nut.
5. Check a course of the lever of the hand brake.