Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Air removal from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the hand brake of back disk brakes
   8.13. Adjustment of the hand brake
   8.14. Cable of the hand brake
   8.15. Switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









8.7. Wheel cylinder of brakes
GENERAL INFORMATION

Details of the wheel cylinder of brakes with a horizontal arrangement of blocks

Details of the wheel cylinder of brakes with a vertical arrangement of blocks

 1. Cap

2. The union for pumping

3. Cover

4. Piston

5. Cuff

6. Spring

7. Cylinder

The scheme of installation of cylinders on brakes with a horizontal arrangement of blocks
1. Left wheel
2. Right wheel
 3. Left carving
4. Right carving
Prevention

At detection of a leak replace the cylinder. Cylinders change only in pair on an axis.

Removal

PERFORMANCE ORDER
1. Lift the car.
2. Remove blocks.
3. Clear the wheel cylinder.
4. Unscrew the union (And) a hydraulic actuator and bolts (In), a tube not to disconnect.
5. Unscrew bolts of fastening of the cylinder.
6. Remove the cylinder and muffle tubes.

Dismantling

PERFORMANCE ORDER
1. Turn out the union for pumping, remove dustproof covers, get pistons with cuffs and springs.
2. Wash out details alcohol or brake liquid.
3. Dry and blow cylinder channels.
4. Check a condition of a surface of the cylinder. At detection of strong damages (scratches) replace the cylinder.
5. Grease new cuffs with brake liquid.
6. Establish cuffs on pistons so that edges of cuffs were turned in the cylinder.
7. Collect the cylinder.
8. Establish the cylinder, wrap bolts by hand. Wrap the union and tighten fastening bolts (see fig. The scheme of installation of cylinders on brakes with a horizontal arrangement of blocks).
9. Tighten the union and establish blocks.
10. Remove air from a hydraulic actuator.
11. Check work of brakes.