Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Air removal from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the hand brake of back disk brakes
   8.13. Adjustment of the hand brake
   8.14. Cable of the hand brake
   8.15. Switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









8.3. Blocks of disk brakes (forward or back)
GENERAL INFORMATION
Prevention

Blocks change only in a set on one axis. When cleaning blocks a dust and dirt to delete with wiping by rags moistened in alcohol or special liquid, it is forbidden to blow.

Replacement

PERFORMANCE ORDER
1. Unscrew a stopper of a nutritious tank of brakes.
2. Release nuts of wheels, lift the car and establish on supports.
3. Remove wheels.
4. Attentively check a disk condition (see subsection 8.5).
5. In need of grinding or replacement remove a disk and blocks.
Prevention

At works watch liquid level in a tank, if necessary remove a part of liquid.
6. Remove a spring bracket of a finger.
7. Get the bottom finger of a block.
8. Remove an antinoise spring of blocks.
9. On cars till 1991 remove a W-shaped antinoise spring of blocks.
10. Get the top finger of a block and remove an external block.
11. Drown pistons of the external cylinder.
12. Grease a block basis with antinoise structure.
13. Grease antinoise slips.
14. Grease a reverse side of a block and establish a block in a support.
15. Cultivation of pistons of a support of back brakes needs a clamp. The heel of a clamp rests against a platform near the union, and the screw is rolled, pressing on an external block.
16. Unscrew support bolts.
17. Remove a support of a back brake, take a support aside and fix.
18. Remove blocks from a support arm.
19. Get indicators of wear and an antinoise slip and rearrange on a new block. At detection of wear or deformations replace these details new.
20. Remove persistent plates of blocks and check. At detection of the slightest deformations replace.
21. Establish a new block, an antinoise slip and the wear indicator.
22. Grease overlays of external and internal blocks with antinoise structure and establish a support upside-down.
23. When dismantling a back brake remove basic plates of blocks which it is necessary to replace at their slightest deformation. Rearrange the wear index for thickness of new blocks. At damages indicators replace.
24. At assembly tighten support bolts with the set moment.
25. Press several times a brake pedal, check and restore liquid level in a tank.
26. Check work of brakes.