Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
8.1. Technical characteristics
+ 8.2. ABS system
8.3. Blocks of disk brakes (forward or back)
8.4. Brake support
8.5. Brake disk
8.6. Blocks of drum-type brakes
8.7. Wheel cylinder of brakes
8.8. Main cylinder of brakes
8.9. Hoses and hydraulic actuator tubes
8.10. Air removal from a hydraulic actuator of brakes
8.11. Vacuum amplifier of brakes
8.12. Blocks of the hand brake of back disk brakes
8.13. Adjustment of the hand brake
8.14. Cable of the hand brake
8.15. Switch of a signal of braking
8.16. A regulator of pressure of back brakes (dosing out and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Regulator arrangement
|
|
The regulator of pressure is intended for pressure compensation in back brakes at increase in loading at a back axis. The unit is located over a beam of the back bridge and contains the valve, торсион and an adjusting bolt. |
At air removal from brakes the regulator is pumped over in the last turn.
If abnormal work of a regulator is noted, hand over the car in car-care center for check and adjustment.
At replacement of a regulator put a control label on an adjusting nut which should be tightened and exposed on this label. |
|