Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Air removal from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the hand brake of back disk brakes
   8.13. Adjustment of the hand brake
   8.14. Cable of the hand brake
   8.15. Switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









8.5. Brake disk

Check, removal and installation

PERFORMANCE ORDER
1. Release nuts of wheels, lift the car and establish on supports.
2. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the annex of effort to a disk, it is possible to dress washers).
3. Release the hand brake.
4. On forward disk brakes remove blocks, remove a support, take aside and fix.
5. On back brakes remove a support arm, having unscrewed bolts.
6. Check a disk condition from both parties. At detection of traces of deep development (depth more than 1,0 mm) remove a disk and прошлифуйте.
7. Check palpation, having established the strelochny indicator in 13 mm from disk edge.
8. If palpation on the indicator exceeds norm, remove a disk and прошлифуйте.
Prevention

The disk is recommended to be removed and ground periodically on it is dependent on indicator indications. At least it can be made by hand a small skin to reduce a roughness.
9. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk. On the right value of limiting diameter of a brake drum of the hand brake is specified.
10. Check thickness of a disk. Measure thickness in several places.
11. After checks remove a nave, unscrew bolts and remove a disk.
12. At assembly tighten bolts with the set moment and adjust bearings.
Prevention

On cars till 1990 it is necessary выпрессовать nave hairpins.
13. A back disk remove, having unscrewed temporarily wrapped up nuts.
14. If the disk does not give in to removal, release the adjusting screw of the hand brake and a rubber hammer bring down a disk.
15. At assembly of forward brakes put greasing and adjust bearings (see subsection 2.39).
16. Establish a back disk on hairpins, establish an arm of a support and tighten all fastenings with the set moment.
17. Establish blocks and antinoise plates.
18. Establish a support and tighten fastening bolts.
19. After assembly press several times a brake pedal.
20. Check work of brakes.