Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. Verkhneklapanny engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Types of repair without engine dismantle
      3.2.3. Cover of a head of cylinders
      3.2.4. A soaking-up collector
      3.2.5. Final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. Head of cylinders
      3.2.8. Cover of a chain drive of cam-shafts
      3.2.9. Forward epiploon of the crankshaft
      3.2.10. Oil pallet
      3.2.11. Oil pump
      3.2.12. Flywheel (a leading disk of the hydrotransformer)
      3.2.13. Back epiploon of the crankshaft
      3.2.14. Suspension bracket and engine details
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.2.11. Oil pump
GENERAL INFORMATION

Details of the oil pump
1. Pump (a forward cover)
2. Spring
3. Cap
4. Laying
5. Reduktsionny valve		 6. Laying
7. A conducted rotor
8. Leading rotor
9. Pump cover
10. Crankshaft epiploon

Removal

PERFORMANCE ORDER
1. Remove belts and a roller of a natyazhitel.
2. Remove the pallet.
3. Remove a pulley of the crankshaft and a forward cover.
4. Unscrew 7 screws (are specified by shooters) and remove the case of the oil pump.
5. Remove from the demountable planes of the pump and the block of cylinders the consolidation remains, wash out the planes solvent.
6. Get conducting and conducted rotors.
7. Disassemble the reduktsionny valve. A cap turn out carefully, holding with effort, as a valve spring the very rigid.

Check
PERFORMANCE ORDER
1. Wash out all details in solvent, check existence of wear and damages.
2. Check a condition of a sliding surface of the piston of the reduktsionny valve and a spring. At detection of damages the piston complete with a spring replace.
3. Check shchupy a gap between a conducted rotor and the case.
4. Check a face gap between a rotor and a cover.
5. Check a gap in gearing of rotors.
6. If gaps exceed norm, rotors in a set replace. If necessary replace the pump case (a forward cover).

Installation

PERFORMANCE ORDER
1. Oil rotors for the engine and establish in the case.
2. Put in a pump cavity technical vaseline, lay laying, put a cover and tighten screws.
3. Grease the piston of the reduktsionny valve with fresh oil for the engine and establish valve details.
4. Establish new laying of a cover of a chain on directing pins.
5. Replace laying of the oil channel of a cover.
6. Establish a chain cover, having entered a leading rotor of the oil pump into gearing with a leading gear wheel of the crankshaft.
7. Establish other details upside-down.
8. Fill in oil, start the engine, be convinced of lack of leaks.