Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. Verkhneklapanny engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Types of repair without engine dismantle
      3.2.3. Cover of a head of cylinders
      3.2.4. A soaking-up collector
      3.2.5. Final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. Head of cylinders
      3.2.8. Cover of a chain drive of cam-shafts
      3.2.9. Forward epiploon of the crankshaft
      3.2.10. Oil pallet
      3.2.11. Oil pump
      3.2.12. Flywheel (a leading disk of the hydrotransformer)
      3.2.13. Back epiploon of the crankshaft
      3.2.14. Suspension bracket and engine details
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.2.12. Flywheel (a leading disk of the hydrotransformer)

 Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight. Lift the car and establish on supports. Remove transmission (check point).
2. Remove coupling.
3. Designate labels the provision of a flywheel concerning the crankshaft.
4. Unscrew flywheel bolts (a leading disk of the hydrotransformer). Fix a flywheel from a provorachivaniye, having rested a screw-driver against a gear wreath.
5. Carefully remove a flywheel (a leading disk of the hydrotransformer). On some cars with automatic transmission on both parties of a leading disk remote washers which store together with a disk are established.

Installation
PERFORMANCE ORDER
1. Clear a flywheel, check existence on a surface of traces of deep development, furrows from rivets, traces of burning out and scratches. It is possible to eliminate insignificant damages with cleaning by a skin. Check deformation of the plane of a flywheel.
2. Clear and check a condition of the plane of the socket of a flywheel and the crankshaft. If it is revealed that the back epiploon of the crankshaft leaks before establishing a flywheel (a leading disk) replace an epiploon.
3. Establish a flywheel (a leading disk of the hydrotransformer) on the crankshaft. Combine the labels put at removal. Before a wraparound of bolts grease carvings with fixing structure.
4. Fix a flywheel a screw-driver for a gear wreath and tighten fastening bolts with the set moment. Tighten opposite bolts. A final inhaling execute for three-four stages.
5. Further assembly is carried out upside-down.