Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. Verkhneklapanny engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Types of repair without engine dismantle
      3.2.3. Cover of a head of cylinders
      3.2.4. A soaking-up collector
      3.2.5. Final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. Head of cylinders
      3.2.8. Cover of a chain drive of cam-shafts
      3.2.9. Forward epiploon of the crankshaft
      3.2.10. Oil pallet
      3.2.11. Oil pump
      3.2.12. Flywheel (a leading disk of the hydrotransformer)
      3.2.13. Back epiploon of the crankshaft
      3.2.14. Suspension bracket and engine details
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.2.3. Cover of a head of cylinders

Removal

PERFORMANCE ORDER

1. Disconnect the battery from weight.
2. Remove an air inlet, disconnect from a cover hoses of ventilation of a case.
3. Remove caps of candles, disconnect wires.
4. Disconnect cables of a butterfly valve and cruise control and take aside. Remove a hook for engine posting in a forward part of a soaking-up collector.
	5. Unscrew bolts of a cover of a head of cylinders, uncover also laying. If the cover does not give in, displace it in hammer blows through a soft pro-rate, or carefully open consolidation by a shpatel.

Installation

PERFORMANCE ORDER

	1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish new laying in a cover flute (laying can be not changed if it did not harden and on it there are no damages). Track safety of sealants of casings of candles (are specified by shooters).
	2. Put hermetic on semicircular caps (are specified by an arrow) and establish them on a head of cylinders.
3. Establish a cover and wrap bolts.
4. Evenly tighten cover bolts with the set moment.
5. Establish other details, start the engine and be convinced of lack of a leak.