Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. Engines 2F and 3F-E
- 3.2. Verkhneklapanny engine 1FZ-FE
3.2.1. Technical characteristics
3.2.2. Types of repair without engine dismantle
3.2.3. Cover of a head of cylinders
3.2.4. A soaking-up collector
3.2.5. Final collector
3.2.6. Cam-shafts and pushers
3.2.7. Head of cylinders
3.2.8. Cover of a chain drive of cam-shafts
3.2.9. Forward epiploon of the crankshaft
3.2.10. Oil pallet
3.2.11. Oil pump
3.2.12. Flywheel (a leading disk of the hydrotransformer)
3.2.13. Back epiploon of the crankshaft
3.2.14. Suspension bracket and engine details
+ 3.3. Dismantle and major maintenance of the engine
+ 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Prevention
If the collector is disconnected only for removal of a head of cylinders, unscrew bolts and take him aside, without disconnecting hoses and wires. Procedure of dismantle of a collector from the engine as separate detail below is described.
Removal
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Execute a decompression of fuel system (see subsection 5.2.2) |
| 3. Designate and disconnect from a collector vacuum hoses. |
| 4. Remove the zaslonka case (see subsection 5.2.9.2.1) and the leveling chamber (see subsection 5.2.9.2.6). |
| 5. Remove a comb of the distributor of fuel and a nozzle (see subsection 5.2.9.2.5). |
| 6. Designate and disconnect hoses from the valve of a retsirkulyatsiya and from the modulating vacuum valve. Turn out from a collector a retsirkulyatsiya tube. |
|
7. Disconnect from a collector a wire on weight (the junction is specified by an arrow).
|
|
8. Unscrew bolts and nuts (are specified by shooters) and remove a collector.
|
Prevention
Working from below the car disconnect brackets of fastening of wires, the bottom bolts and 2 nuts of fastening of pair of steel tubes to a collector.
|
|
Installation
| PERFORMANCE ORDER |
| 1. Clear a collector, check a condition of the demountable plane, if necessary прошлифуйте. |
| 2. Establish new laying, establish a collector and wrap bolts and nuts. |
| 3. Tighten bolts and nuts evenly, with the set moment, being displaced from the center to the periphery. |
| 4. Establish other details upside-down. |
| 5. Before start of the engine check freedom of moving of a cable of a butterfly valve. |
| 6. Start the engine and be convinced of lack of a leak of cooling liquid and tightness of vacuum connections. |
| 7. Check the car in road conditions. |
|
|
|