Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
- 11. Electric equipment
11.1. Search of malfunctions
11.2. Safety locks
11.3. Fusible crossing points
11.4. Breakers
11.5. Relay
11.6. Breaker of indexes of turn / alarm system
11.7. A combination of switches on a steering column
11.8. Lock of ignition and lock drum
11.9. Indexes of level of fuel, pressure and oil temperature
11.10. Guard of devices
11.11. Screen wiper electric motor
11.12. Receiver and loudspeakers
11.13. Aerial
11.14. Heater of back glass
11.15. Headlights
11.16. Case of a halogen headlight
11.17. Sound signal
11.18. Replacement of lamps
11.19. Lateral mirrors with the electric drive
11.20. System cruise control
11.21. Window regulator electric drive
11.22. Electric drive of door locks
11.23. Safety cushions
+ 12. Electroschemes
|
The heater consists from thin a provolok, baked with a glass surface.
Small destructions can be repaired a provolok independently.
Check
| PERFORMANCE ORDER |
| 1. Include ignition and a heater. |
|
2. Dress on щуп the voltmeter the combined strip of an aluminum foil and press down a finger to a heater thread. |
|
3. If tension is equal in the center of a thread 6 In, the thread is serviceable, if tension is equal 12 In, the thread is torn off (break takes place between the center of a thread and weight). If tension 0 In, the thread is torn off between the center and feeding conclusion of a heater. |
| 4. If threads are serviceable, connect (-) a heater conclusion to weight. If indications of the voltmeter change, connection with weight the unsatisfactory. |
|
5. It is possible to establish a place of break of a thread conducting aluminum contact on щупе the voltmeter on a thread aside from (+) a conclusion to (-) to a heater conclusion. (-) a conclusion of the voltmeter connect to aluminum contact. The indication of the voltmeter should increase in a break place from 0 to several volts. |
|
Repair
| PERFORMANCE ORDER |
| 1. Срастить the torn-off thread of a heater it is possible by means of carrying-out epoksidny structure of Dupont N 4817 or equivalent. |
| 2. Disconnect a heater and wait complete cooling. |
| 3. A steel sponge carefully располируйте the damaged site also wipe alcohol. |
| 4. Impose on the damaged site a mask from a sticky tape. |
| 5. Prepare pitch, being guided by the instruction. |
|
6. Put structure on a crack in a mask, smearing approximately on 18 mm in both parties. |
| 7. 24 hours later unmask. |
|
|
|