Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
- 11. Electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crossing points
   11.4. Breakers
   11.5. Relay
   11.6. Breaker of indexes of turn / alarm system
   11.7. A combination of switches on a steering column
   11.8. Lock of ignition and lock drum
   11.9. Indexes of level of fuel, pressure and oil temperature
   11.10. Guard of devices
   11.11. Screen wiper electric motor
   11.12. Receiver and loudspeakers
   11.13. Aerial
   11.14. Heater of back glass
   11.15. Headlights
   11.16. Case of a halogen headlight
   11.17. Sound signal
   11.18. Replacement of lamps
   11.19. Lateral mirrors with the electric drive
   11.20. System cruise control
   11.21. Window regulator electric drive
   11.22. Electric drive of door locks
   11.23. Safety cushions
+ 12. Electroschemes









11.19. Lateral mirrors with the electric drive
GENERAL INFORMATION

The chart for check of the switch of lateral mirrors on FJ80 cars and designation of contacts of the socket

The mirror drive in the majority of models is carried out from 2 electric motors of vertical and horizontal shift.

Check

PERFORMANCE ORDER
1. Include ignition (the engine not to start) and lower lateral glasses. The selector which has been built in in the switch, include the necessary mirror and check work of a drive of the right and left mirrors, displacing them to the right and to the left, up and down.
2. Hear to operation of electric motors.
3. If operation of electric motors is listened, and the mirror does not move, the drive mechanism in a mirror is faulty. Remove a mirror and disassemble.
4. If operation of electric motors is not listened and mirrors do not move, check a safety lock.
5. If the safety lock is serviceable, get the switch, without disconnecting wires. Include ignition and check tension on the switch. If tension is not present, check wires from a safety lock to the switch. Otherwise check the switch for what execute the following.
6. Disconnect the socket and check a switch chain according to the enclosed chart. If contacts do not become isolated in a specified way, the switch replace.
7. Attach the switch. Find a wire from the switch on weight. Without disconnecting the switch close a crossing point this wire on weight. If the mirror works normally with a crossing point, repair "regular" connection with weight.
8. If the mirror does not work, disassemble a mirror and check tension existence on wires. Include ignition and transfer the switch to all provisions, checking tension. On one of wires from the switch there should be a tension in each its situation (except for the situation Off).
9. If tension is absent, check a chain from a mirror to the switch.
10. If tension is, remove a mirror and check its work, having executed connection through crossing points. If the mirror does not work, replace it.