Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
- 11. Electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crossing points
   11.4. Breakers
   11.5. Relay
   11.6. Breaker of indexes of turn / alarm system
   11.7. A combination of switches on a steering column
   11.8. Lock of ignition and lock drum
   11.9. Indexes of level of fuel, pressure and oil temperature
   11.10. Guard of devices
   11.11. Screen wiper electric motor
   11.12. Receiver and loudspeakers
   11.13. Aerial
   11.14. Heater of back glass
   11.15. Headlights
   11.16. Case of a halogen headlight
   11.17. Sound signal
   11.18. Replacement of lamps
   11.19. Lateral mirrors with the electric drive
   11.20. System cruise control
   11.21. Window regulator electric drive
   11.22. Electric drive of door locks
   11.23. Safety cushions
+ 12. Electroschemes

11.2. Safety locks

GENERAL INFORMATION

Chains of electric equipment of the car are protected by safety locks, breakers or fusible crossing points.

The assembly block of safety locks is mounted in salon or in a motor compartment, depending on year of release and car model.

The block of safety locks on FJ80 cars

The block of safety locks is mounted under the forward facing panel and closed by a cover (on FJ60 cars and the 62nd arrangement is similar).

The block of safety locks and the relay in a motor compartment on FJ80 cars

A.Predokhraniteli

Century. Fusible inserts

S.Rele

On a cover of the assembly block the chain which protects this safety lock is specified. At chain refusal first of all check a safety lock. Safety locks are established on contacts of knife type and get by hand. The fused safety lock easily is found on appearance.

Appearance of safety locks

At the left – the fused safety lock.

On the right – a serviceable safety lock.

It is possible to check also tension on conclusions. The safety lock fused if the voltmeter shows tension. To replace a safety lock get faulty and insert new, having pushed it into a nest.

The rated current of a new safety lock should correspond in accuracy to a current of the replaced. The rated current is specified on a safety lock. It is forbidden to use wire pieces instead of a safety lock. If the new safety lock immediately fuses, find the reason and eliminate. As a rule the peregoraniye is caused by short circuit of wires because of their retyranny.