Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
- 11. Electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crossing points
   11.4. Breakers
   11.5. Relay
   11.6. Breaker of indexes of turn / alarm system
   11.7. A combination of switches on a steering column
   11.8. Lock of ignition and lock drum
   11.9. Indexes of level of fuel, pressure and oil temperature
   11.10. Guard of devices
   11.11. Screen wiper electric motor
   11.12. Receiver and loudspeakers
   11.13. Aerial
   11.14. Heater of back glass
   11.15. Headlights
   11.16. Case of a halogen headlight
   11.17. Sound signal
   11.18. Replacement of lamps
   11.19. Lateral mirrors with the electric drive
   11.20. System cruise control
   11.21. Window regulator electric drive
   11.22. Electric drive of door locks
   11.23. Safety cushions
+ 12. Electroschemes

11.8. Lock of ignition and lock drum

GENERAL INFORMATION

The chart for check of the lock of ignition on FJ60 cars

The chart for check of the lock of ignition on FJ62 cars

The chart for check of the lock of ignition on FJ80 cars

Check

PERFORMANCE ORDER

1. Disconnect the socket of the lock of ignition, having found it on wires.

2. An ohmmeter or a control lamp check chain existence between the specified conclusions, in different provisions of a key. Replace the lock if results at least with one of checks the negative.

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. Transfer a key to situation ASS.

3. Remove a wheel.

4. Remove a casing of a steering column.

5. Remove from a wheel shaft a combination of switches.

Replacement of the lock of ignition

6. Disconnect sockets of wires.

7. Unscrew screws of fastening and remove the lock.

8. Installation is carried out upside-down.

Replacement of the switch (drum) of the lock

9. On a part of cars get a ring of illumination of the lock.

10. Press a pin, remove the lock, having submitted it up.

11. At installation of the lock press on a pin and insert the lock into an opening before fixing by a pin.

12. Further assembly is carried out upside-down.