Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.1.12. Forward epiploon of the crankshaft
GENERAL INFORMATION
Prevention

It is possible to replace an epiploon without removal of a forward cover. However access to an epiploon extends and more convenient to work if cover to remove.

Epiploon replacement without removal of a forward cover

PERFORMANCE ORDER
1. Disconnect the battery from weight. Remove a crankshaft pulley (see subsection 3.1.11).
2. Remember orientation of an epiploon and having hooked, take an epiploon.
3. Slightly grease an external surface and working edges of a new epiploon with oil for the engine and press a new epiploon without distortions by means of an opravka with a diameter a little smaller than diameter of an epiploon. The forward surface of an epiploon should be aflush with a forward cover.
4. Establish a pulley.

Epiploon replacement with cover removal

PERFORMANCE ORDER
1. Remove a forward cover.
2. Hook and get an epiploon. At considerable run of the engine fill in getting liquid in a gap between an epiploon and the case and wait time, sufficient for impregnation.
3. Clear an opening under an epiploon and slightly grease an external surface and working edges of a new epiploon with oil for the engine.
4. Carefully without distortions press a new epiploon into place by means of an opravka with a diameter a little smaller than diameter of an epiploon (a photo at the left) or blows through whetstone (a photo on the right).
5. Establish other details upside-down.