Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes


learn with ai






3.1.21. Suspension bracket and engine details
GENERAL INFORMATION

Engine mount details as a rule do not demand leaving, however, at detection of damage of support of the engine, or their aging, it is necessary to replace them immediately.

Check

PERFORMANCE ORDER
1. At check the engine should be raised a little to unload support.
2. Lift the car and establish on supports, then place under the oil pallet of the engine a support. Lay between the pallet and a support a board lower the car a little.
3. Check existence on support of cracks, hardenings or an otsloyeniye from a metal basis.
4 whether. Check plates of support concerning the engine or a frame (for this purpose shake support mount, or a big screw-driver) move. If moving is felt, lower the engine and tighten fastenings of support.
5. For delay of aging grease rubber details of support with preserving means.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight, lift the car and establish on supports.
2. Unscrew a nut of a through bolt of a support.
3. Raise the engine (a jack or a waist), get a bolt and remove a support.
4. Installation is carried out upside-down. Grease carvings of nuts and bolts with fixing structure and reliably tighten.