Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.1.19. Flywheel (a leading disk of the hydrotransformer)

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports. Remove transmission (check point).
2. Check and if necessary replace a check point epiploon (a sealing ring on automatic transmission).
3. Remove coupling (on a manual transmission).
4. Designate labels the provision of a flywheel concerning the crankshaft.
5. Unscrew flywheel bolts (a leading disk of the hydrotransformer). Fix a flywheel from a provorachivaniye, having rested a screw-driver against a gear wreath.
6. Carefully remove a flywheel (a leading disk of the hydrotransformer).

Installation

PERFORMANCE ORDER
1. Clear a flywheel, check existence on a surface of traces of deep development, furrows from rivets, traces of burning out and scratches. It is possible to eliminate insignificant damages with cleaning by a skin. Check deformation of the plane of a flywheel.
2. Clear and check a condition of the plane of the socket of a flywheel and the crankshaft. If it is revealed that the back epiploon of the crankshaft leaks before establishing a flywheel (a leading disk of the hydrotransformer), an epiploon replace.
3. Establish a flywheel (a leading disk of the hydrotransformer) on the crankshaft. Combine the labels put at removal. Before a wraparound of bolts grease carvings with fixing structure. On a part of cars the flywheel is established on pins.
4. Fix a flywheel a screw-driver for a gear wreath and tighten fastening bolts with the set moment. Tighten opposite bolts.
5. Further assembly is carried out upside-down.