Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.1.17. Oil pallet

GENERAL INFORMATION

Oil pallet of the engine 3F-E

1. Oil pump
2. The roller of a conducted gear wheel
3. Leading gear wheel
4. A conducted gear wheel
5. Maslopriyemnik
6. Reduktsionny valve
7. Spring
8. Cap
9. Oil pallet
10. Drain stopper
11. Laying
12. Final branch pipe
13. Roller of a leading gear wheel

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Lift a car front.
3. Merge oil and remove the oil filter.
4. Disconnect an exhaust pipe from a collector.
5. Remove a starter and a cover of a bell-shaped case.
6. Unscrew pallet bolts (see fig. The oil pallet of the engine 3F-E) also remove the oil pallet. If necessary displace the pallet in easy blows of a wooden or rubber hammer.

Installation

PERFORMANCE ORDER
1. Remove from the demountable planes of the block of cylinders and the pallet the consolidation remains. Wash out the condensed planes solvent.
2. Establish new laying.
3. Establish the pallet and wrap bolts. Tighten pallet bolts with the set moment, beginning an inhaling on corners and continuing in a diagonal order.
4. Further assembly are carried out upside-down. Fill in oil in the engine and replace the filter. Start the engine and be convinced of lack of leaks.