Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




3.1.4. Cover of a head of cylinders

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight (be convinced that radio tape recorder codes are known).
2. On carburetor engines remove the air filter, on injector remove an air inlet hose, the sensor of speed of a stream and the air filter.
3. Designate and disconnect all hoses and wires which can prevent removal of a cover of a head of cylinders.
4. Unscrew bolts of a cover of a head of cylinders, uncover also laying. If the cover does not give in, displace it in hammer blows through a soft pro-rate, or carefully open consolidation by a shpatel. It is forbidden to separate a cover, inserting the tool between demountable surfaces.

Installation

PERFORMANCE ORDER
1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish new laying in a cover flute (laying can be not changed if it did not harden and on it there are no damages). Replace a sealant of bolts of a cover.
2. Carefully establish a cover and wrap bolts.
3. Evenly tighten cover bolts with the set moment.
4. Establish other details, start the engine and be convinced of lack of a leak.