Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.1.13. Forward cover

Removal

PERFORMANCE ORDER
1. Remove a crankshaft pulley.
2. Remove the fan (see subsection 4.4).
3. Remove the compressor of the conditioner and an arm with the generator, take aside.
4. Unscrew bolts of fastening of a cover.
5. Carefully uncover the engine.

Installation

PERFORMANCE ORDER
1. Remove the remains of consolidation and replace an epiploon.
2. Put on the cover plane hermetic, establish a cover and wrap bolts.
3. Two bottom bolts wrap on hermetic. In drawing designation of bolts of a forward cover on the engine 3F-E (see subsection 3.1.1) is given. Grease carvings of bolts And hermetic.
4. Establish a crankshaft pulley.
5. Tighten cover bolts.
6. Establish other details upside-down. Start the engine and be convinced of lack of a leak.