Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without engine dismantle
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Lateral cover of the mechanism of a gazoraspredeleniye
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, maslosjemny caps
      3.1.8. Soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and drive gear wheels
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (a leading disk of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Suspension bracket and engine details
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and major maintenance of the engine
   + 3.4. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes









3.1.18. Oil pump

GENERAL INFORMATION

Prevention

The oil pump is recommended to be changed at each removal of the pallet.

Before drawing a final conclusion, check pressure of oil in greasing system.


Cнятие

PERFORMANCE ORDER
1. Remove the pallet.
2. Unscrew 2 bolts of fastening of the pump.
3. Remove the pump with a maslopriyemnik.
4. If the pump is faulty, replace it. This unit is not subject to repair.

Installation

PERFORMANCE ORDER
1. Turn the pump roller so that the groove of the roller (1) coincided with shlitsy a shaft (2) rollers of the distributor. The pump should come without effort into place. If the pump does not come, remove it and tighten before groove coincidence with the shlitsy.
2. Further assembly is carried out upside-down. Fill and start the engine, be convinced of lack of a leak.